Atem Television Studio:inactive HDMI inputs and SDI inputs

2 posts / 0 new
Last post
Offline

Location

Ikeja,
Nigeria
Joined: 17/12/2016
Posts: 1
Atem Television Studio:inactive HDMI inputs and SDI inputs

1. ATEM Television studio is not active to recieve input from hdmi 1and 2 camera and sdi input 5 and 6.Only port 3 and 4 active. What do i do to make them active so as to seeother cameras input?

2. How do I update my ATEM Television Studio?

My Johnson

thos-berlin's picture
Offline

Location

berlin
Germany
Joined: 19/06/2012
Posts: 454
Inputs 1&2 and 5&6 are always

Inputs 1&2 and 5&6 are always active, So when you tried it with the same camera and cable (!!!!)that works at inputs 3&4, there is a faillure.

Maybe only a faulty software installation. Donwload a different ATEM control software from Blackmagic site and install on your controllng computer. After this, the software indicates an version conflict to ATEM firmware and you must install the "new" firmware, as described in manual You can downgrade the same way.

If reinstalling don't solve the problem,  contact your dealer. Then the unit may have a hardware issue.

Thomas  S e e w a l d - thos-berlin (amateur)